Demon screws and washers to mount your bindings to your snowboard.
Product ID: 9012 DS0950a 895722142769
Pack of 8 screws and washers by Demon. Perfect for mounting bindings onto snowboards.
All snowboards and snowboard bindings use the same diameter screw, which is size M6, with the same size thread. The only thing which varies is the length of the screw. It is the thickness of your binding baseplate which determines what length screw you require. This varies from manufacturer to manufacturer and from binding to binding.
The make and model of your snowboard is irrelevant as they all use the same inserts. To measure the length of a screw, measure from the threaded tip up to the widest point on the circumference of the screw head.
Pack of 8 screws and washers
12mm: As used by many K2 and Ride Bindings. K2 and Ride bindings tend not to use the washers so just chuck 'em away!
14mm: This is the 'standard' size suitable for most makes of binding, including older models of Burton and 2007 Flow NXT bindings and all Flow bindings 2008 onwards
16mm: Most Burton bindings
18mm: All Flow bindings pre 2008 - except Team and NXT
**If in doubt, use a shorter screw! If the screw is too long and you tighten it hard, it can punch a hole in the bottom of your board! The advice we give on this page is only advice; we are not recommending that you buy any particular length screws. If you order the wrong size screws we can't accept responsibility for this, sorry. We recommend you measure one of your old screws before ordering**
We have selected the following pages from our Advice Centre as possibly the most relevant for you.
If you have a Capita Snowboard, you will need 14mm screws if your bindings are a plastic base. 16mm are too long and you get movement from the binding. had no problems with the 14mm screws.
They do exactly what they are supposed to do. Its worth having a spare set in your bag. I managed to go to Winter Park last season and leave my screws at home. No where sold them. Luckily they lent me some from the rental shop.
Does the job
What did you expect?
These are screws. They screw things on to other things. And for that job they're pretty good. Better than: blu-tack, duct tape, chewing gum, staples, glue, rope and magnets.
Can't fault worked perfectly with board and bindings for 14 days straight with no need to re tighten.
Did the job - I was actually just after the washers which are a nightmare to find. These guys did the best price and the product was good.
Need 'bedding in'
They don't sit in their washers flush at first, so they seem too short. I was going to return them for longer ones but I managed to get some thread in. Then when I tightened them up they squashed into the washers and shaped the washer to the screw. Now they sit deep and flush. Not as nice as the Rome 390 screws that came with my bindings, but fine as cheap spares.